Naze 32 Rev6 6DOF Flight Control Board for FPV Multicopter
Designed for use with small indoor or small to mid-sized outdoor multirotor crafts, or as a standalone camera stabilizer.
The Naze32 flight controller is extremely simple to setup, with configuration based on the familiar “MultiWii” software.
Designed for use with small indoor or small to mid-sized outdoor multirotor crafts, or as a standalone camera stabilizer.
The Naze32 flight controller is extremely simple to setup, with configuration based on the familiar “MultiWii” software.
Features:
Sensors: MPU6050
Battery voltage monitoring
Built-in FrSky telemetry converter
Modern 32-bit processor (STM32 F103) running at 3.3V/72MHz.
Onboard USB for setup and configuration
Extra bright LEDs
Modern GUI for all operating systems, Baseflight Configurator
Specifications:
36x36mm size
Weight: 6 grams (no headers, 8 grams with)
Version: 6DOF, does not have compass and barometer.
Version: 10DOF, with compass and barometer.
Headers:
1x 3x6 90 degree pin headers,
1x 1x2 straight pin headers,
1x 2x3 90 degree pin headers,
1x 2x5 straight pin headers.
Please note these the pins are not soldered to the board.
Additional Notes:
If you do not have a CPPM enabled Receiver, you will also need to purchase the RC Breakout Cable