T-REX 700E 3G Combo

●3-axis gyroscopic flybarless system to simulate the stability of mechanical flybar system, yet at the same time achieving agile 3D performance.
●Utilizes Silicon Micro Machine (SMM) sensors for excellent stability.
●12 bit processors providing ultra high resolution, resulting in highly precise controls
●Software upgradable through PC interface adapter
(sold eparately)
●Simplistic setup process without the need of external devices. Setup is done through 5 steps and 2 sensitivity adjustments. Rudder setup is identical to GP780 gyro, minimizing learning curve.
●Flybarless system dramatically improves 3D power output and efficiency, resulting in reduced fuel or electricity consumption.
●Highly sensitive gyroscopic sensors combined with advanced control detection routine providing higher hovering and aerobatic stability than other flybarless system.
●Suitable for all CCPM and mechanical mixing system.
●Comaptible with helicopter of all sizes from T-Rex 250 to T-Rex 700.
●Innovative Pitch Gau as an aid to facilitate pitch adjustments.
●High frame rate signal output for faster and higher precision servo response.
●Capable to operate between 3V to 8.4V, compatible with high voltage servos.
●Small footprint, light weight, minimalists and reliable design.

●Suitable Voltage Range:DC 3~8.4V
●Current Comsumption:<80mA @ 4.8V>
●Flip and Roll rate detection speed: :±300degrees/sec
●Rudder rate detection speed:±500degrees/sec
●Sensor resolution: 12bit
●Operating temperatur:-20℃~65℃
●Operating humidity:0%~95%
●RoHS certified
●Dimension:
Control box:42x26.5x14.5mm
Sensor:22.3x21.7x14mm
●Weight:
Control box:16g
Sensor:9g

● Length: 1328mm
● Height: 408mm
● Main Blade Length: 690mm
● Main Rotor Diameter: 1562mm
● Tail Rotor Diameter: 281mm
● Motor Drive Gear:12T
● Main Drive Gear:115T
● Autorotation Tail Drive Gear: 104T
● Tail Drive Gear: 24T
● Drive Gear Ratio: 1:9.58:4.33
● Weight(With Motor): 2830g
● Flying Weight: Approx. 4700g

Accessories

●T-REX 700E 3G Kits Set X1
●Aluminum Tail Boom X1
●3K Carbon Fiber Tail Boom X1
●690D Carbon fiber blades X1
●DS610 Digital servoX3 set
●DS650 Digital servo X1
●Flybarless System X1 set
●700M Brushless Motor X1
●105mm 3K Carbon Fiber Tail Blades X1 Set


Radio transmitter and electronic equipment required for assembly:
●Transmitter(7-channel or more, helicopter system)
●Receiver(7-channel or more)
●ESC (12S Li-Po 80A or more)
●5A and higher external BEC(uses when ESC doesn have BEC build in)
●6S Li-Po 4500 ~ 5200mAh X2
●Dial Pitch Gauge